Last night it looks like I fragged another xbox. On this 1MB v1.1 xbox I was performing the 007AUF TSOP flash hack.
I first ran raincoat and received manf=0x09, dev=0x00. I knew this meant my soldering job was not up to speck. I did it again and then when I ran raincoat I received this.
# ./raincoat -p bios.bin
raincoat Flasher 0.5 Apr 14 2003
[email protected] http://xbox-linux.sf.netReading /etc/raincoat.conf... (unable to open /etc/raincoat.conf, using default
list)
DETECTED: ST M29F080A (1024K)
Programming with bios.bin...Read 1048576 bytes from file
Erasing...
Trying to erase whole chip
ERASE ERROR AT +0x0...read 0x0B
Done
Error: Erase failed for block at +0x0, reads as 0x0B
Could your chip be write-protected?
Completed
When I tried again I received.
UNKNOWN DEVICE Read Only??? manf=0xFF, dev=0xFF
Try adding the device ID to /etc/raincoat.conf
Now my xbox frags. From what I read I might or might not be able to perform the MatrixTSOP Flash repair (it depends on if I have a partial bios or not). I'm going to try
So, You Screwed Up Your X-box, How to make things work... and see if that will let me repair this.
More importantly I would like to know what happened. What would cause it to start erasing and then crap out right after it started? I have used this same bios file in a mutiplitude of xboxs and did everything for the most part the same.
Thanks for yout input.
