xboxscene.org forums

OG Xbox Forums => Modchip Forums => Team DMS Chips (X-B.I.T) => Topic started by: jasonramalho on February 10, 2006, 08:13:00 PM

Title: D0 Mis Alignment
Post by: jasonramalho on February 10, 2006, 08:13:00 PM
hello all

i have a 1.0 xbox and a 1.5 xbit chip

i have modded an xbox before with the xbit chip on a newer xbox without a problem.

on the on i am trying to mod now i am having a problem...... the d0 does not seem to line up correctly. i keep getting red flashing light and a "xbox needs service" screan. has anyone else had this problem?
Title: D0 Mis Alignment
Post by: Silentscream__ on February 13, 2006, 05:58:00 AM
Flashed the bios? Set the switch? Scraped and cleaned the d0 point?

If you've done all these things, then the only option really is to keep trying!

Title: D0 Mis Alignment
Post by: jasonramalho on February 13, 2006, 04:06:00 PM
i have tried everything......the chip d0 pins are not lining up with the do points on the motherboard. does this mean this chip is defective? it says the xbit .5 works with a 1.0 xbox so this should fit properly right?
Title: D0 Mis Alignment
Post by: jasonramalho on February 13, 2006, 07:06:00 PM
got it smile.gif  ..... thank
Title: D0 Mis Alignment
Post by: jack_pearce on February 14, 2006, 10:41:00 AM
QUOTE(jasonramalho @ Feb 14 2006, 02:13 AM) View Post

got it smile.gif  ..... thank

hehe I had your exact same problem. The d0 point is a tricky thing.
Title: D0 Mis Alignment
Post by: Jordan_23 on July 05, 2006, 11:50:00 PM
I am having this problem also, how can I solve it? The pogo pins are nowhere near the d0 pin, they go further out and reach some other hole which is not the correct one