xboxscene.org forums

Xbox360 Forums => Xbox 360 Newbie Forums => Newbie Chat => Topic started by: boberto on January 01, 2008, 08:56:00 PM

Title: E65 Error
Post by: boberto on January 01, 2008, 08:56:00 PM
I just used Iprep to set up flash drive with iextreme 1.4 on my  ms28 drive.  I was able to complete the dsam and did all the banks.  I rebooted and saved the file "SAM-OFW.BIN".  When i went back and tried to do the fsam command, it wont.  I plugged the xbox into my pc and am getting error E65.  I have read the tutorials over and over. Am i missing something?
Thanks.
Title: E65 Error
Post by: McLovin on January 01, 2008, 10:14:00 PM
you have to use the latest iprep
Title: E65 Error
Post by: boberto on January 01, 2008, 10:55:00 PM
thank you. i just noticed that there is a new version. Do i need to backup to the orignal fw or can i just fsam the new 1.4?
Title: E65 Error
Post by: boberto on January 02, 2008, 03:16:00 PM
someone showed me how to make the ix14.bin file and put it into the tools folder.  When i boot i go to the tools directory, then i typed mtkflash w /m /sata ix14.bin  then it said no device detected.  My via card shows up when i am using fsam and dsam but not with mtkflash.  I have been working on this forever and need some help BADLY.
thanks
Title: E65 Error
Post by: syntaxerror329 on January 04, 2008, 09:37:00 AM
The bat files do it the same way you are doing it from the command prompt using the exact same mtkflash command.

Are you using the VCC method or the 10 second trick?

If you somehow managed to brick the DVD controller board then you should pm me as i just so happen to have a extra Samsung controller without a drive to put it in.  




Title: E65 Error
Post by: syntaxerror329 on January 04, 2008, 11:54:00 PM
Don't stress out too much, You have your key!


Did you hook a ground cable up between your xbox and pc? becuase if not you may have bricked the drive.
Its not a good sign when your unable to even dump the drive any more.  


Title: E65 Error
Post by: Grim187 on January 05, 2008, 01:14:00 AM
either 1 you plugged in the power cable wrong and killed the drive or 2 you have bad flashed it.

you will need another (SATA) device that will register in mtkflash to try the bad flash recovery, another working samsung is best but you can most likely use a sata PC drive or the 360 hard drive.

after getting the other drive registered (with a write command) power it off and disconnect it, connect the samsung in its place, make your selection and power it on, if it doesnt start writing then you need a new drive board or drive.
Title: E65 Error
Post by: syntaxerror329 on January 05, 2008, 01:48:00 AM
I dont think it will help. It is for disabling firmguard but you have a bad flash not a firmguard issue.
Title: E65 Error
Post by: boberto on January 05, 2008, 12:00:00 PM
Is anyone familiar withthe "hot swap method" when flashing?  have read about it and using another sammy drive, but does ti have to be another xbox drive?
Title: E65 Error
Post by: boberto on February 03, 2020, 10:51:00 PM
So for my situation, since i have my original key, would it be best to just buy a new samsung drive online and inject my key in it and reflash the new drive? Also if i buy a MS25 instead of my MS28, i know i need to spoof the drive to be seen as a ms28, but do i still need to do the 10 second trick?