Print

[duranvw]

Alright well I see there are a few tuts on this but I cant seem to figure out exactly where to solder the wire in the xbox for the power button... Do I need to remove that metal shield and the front piece to get access to it? There are 4 solder points behind the eject button Im not sure if either of those are for the power. Ive searched thru this fourm and cant seem to find anything. Thanks  <

[blindbug]

check my sig... I took alot of what I consider, good pics of what/where your wanting to solder...  <

[q3autraven]

if your doing the yellow wire mod then you need to soder it to the second solder point from the bottom on the left side(if your looking front to back and you should remove controller ports 3 and 4 while you soder saves you some trouble-much luck

This post has been edited by q3autraven: Jun 21 2004, 03:06 AM <