xbox-scene.com archived forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

xbox-scene.com forum restored.  registration disabled.  thanks to xboxexpert for the db dump and netham45 for cleaning it up!

Author Topic: Aladdin Advanced Problems - How Can I Make It Boot Without 1 Sec Hold?  (Read 228 times)

Xboxee

  • Guest


I'm on the edge of my patience with this darn Aladdin. The story goes like this, I bought this Xbox a few days ago and it was already modded.

Problem is when I try to boot with modchip on by holding the power button for 1 second like it should do, the LED goes red then orange in quick succession and when I let go of the button it turns green and tries to boot the ms dash. Since I don't have the original hard drive inside it shows me error 05. From 15-20 attempts I managed to boot the Xbox on with the chip just two times (LED turns orange and Xbox logo on screen turns blue).

I opened the Xbox to check it out and everything looks ok, I think. L1 and BT wires are soldered near the power connector and D0 and L2 wires are soldered somewhere under the board (pics below). I think the Xbox is v1.6 because it has Xcalibur chip and Samsung memory.

I read in some other thread that is possible to make chip always on so it would boot with regular quick press on power button. How can I do that, I don't plan ever to boot to ms dash anyway?

Any help is much appreciated!


IPB Image IPB Image





Logged

MrMajst3r

  • Guest
Aladdin Advanced Problems - How Can I Make It Boot Without 1 Sec Hold?
« Reply #1 on: May 30, 2012, 05:04:54 AM »


For always enabled - desolder wires from BT, L1 and solder BT on the chip to GND.





Logged

Xboxee

  • Guest
Aladdin Advanced Problems - How Can I Make It Boot Without 1 Sec Hold?
« Reply #2 on: May 30, 2012, 06:35:19 AM »


Thanks for the reply man, I will try that ASAP!




Logged
 

Page created in 0.12 seconds with 15 queries.