xbox-scene.com archived forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

xbox-scene.com forum restored.  registration disabled.  thanks to xboxexpert for the db dump and netham45 for cleaning it up!

Author Topic: Nandpro Controller Not Detected  (Read 47 times)

guestie

  • Guest
Nandpro Controller Not Detected
« on: July 28, 2011, 03:36:43 PM »


can anyone help me here as was jtagging a xenon xbox everything was going fine got cpu key went to dump xbr to nand but now nandpro wont detect my flash controller.....
I have scouted several forums all saying short this pin short that pin etc.... I do this but still nothing any ideas on how to solve this would be much appreciated

oh am using nandx usb did try ltp as well but no joy. the nandx is ok as can dump and read another xbo im doing.
uhh.gif




Edited by guestie, 28 July 2011 - 11:37 PM.


Logged

ruciz

  • Guest
Nandpro Controller Not Detected
« Reply #1 on: August 17, 2011, 06:19:17 PM »


If you are already running XBR use flash360.

Tips if you are trying to dump an original NAND:

get flux and 99% isopropyl alcohol (usually behind counter at drug store)
remove/desolder everything you wired up from board

clean up wires (using alcohol and small brush/lint-free wipe), remove any solder burs by putting flux on point and retouching with a tinned iron tip. it should reflow nicely.

get a magnifying glass and check that no small solder beads flew off and landed between the TSOP chip pins, shorting them out. if so they should be easy to remove with pure force. Again use judgement, you may need a braid.

using flux on each connection, reinstall the jtag points in the right spots with good looking solid connections. it will detect.




Edited by ruciz, 18 August 2011 - 02:21 AM.


Logged
 

Page created in 0.763 seconds with 15 queries.